![]() ![]() Immediately continue to coat the next section (note: fresh paint can be applied over the loose chips that lay outside the previously painted area). This will not affect the performance of the coating). Sprinkle the decorative paint chips onto the wet film (note: this step may be skipped if chips are not desired. Maintain a wet edge to prevent lap marks and gloss differences. Apply in sections of 1,5 x 1,5 m so that Epoxyshield Decorative Chips can easily be scattered on the freshly coated surface. Application and ThinningĪfter the full 60 minutes use a paint roller (20 cm) to apply an even coat to the surface. Do not mix Paint Chips with Epoxyshield Garage floor coating. This time decreases at higher temperatures. The product must be used within 1 to 2 hours of initial mixing. Do not leave container in direct sunlight. Allow mixed product to stand (see table) before rolling the coating on to the surface. Pour the contents of A into B and stir thoroughly for at least 3 minutes. Remove all water and allow to dry completely. Rinse thoroughly with fresh water afterwards. Remove oil and grease using a scrubbing brush and ND14 cleaner degreaser. If the floor is previously painted, remove any loose paint by sanding and scraping. They give a decorative finish and will also mask dirt. The chips adhere permanently on the floor when they are sprinkled in the wet coating. ![]() The Epoxyshield Decorative Chips are specially designed for use in combination with Epoxyshield Garage Floor Coating. Detailed instructions and a free Instructional DVD.Resists oil, petrol, anti freeze, salt and hot tyre pick up.It can also be applied on sound previously painted floors. Epoxyshield Garage Floor Coating can be applied on concrete floors, which are completely clean and dry. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |